The Easy Way to Get a Broken Key Out of a Lock

The Easy Way to Get a Broken Key Out of a Lock

Keys shatter because of metal fatigue and wear over time. When the key is turned, this breaking can occasionally happen inside the lock cylinder. Don’t get upset if a key breaks off in the lock; it’s an annoying and inconvenient problem. Without contacting a locksmith, there are a number of ways to get rid of a broken key. The best approach for you depends depend on the kind of lock you have, how far away your keys are kept, and how much time you have. At, a sufficient Lock Picking Set can be purchased.

Why do keys break locks

A key can open a door for a variety of reasons. First of all, if too much force is used when turning the key, the key itself may become weaker with time and become more prone to break. The lock may also be broken or have a clogged mechanism as an alternative explanation. We’ll look at some typical issues with keys becoming stuck in locks and discuss ways to avoid them.

How to get a broken key out of a lock

Pinch the broken key out

The key should only be taken from the lock if the serrated or cut face is aligned with the top of the cylinder. The first step is to confirm the alignment. Try rotating it 180 degrees in this instance. When the retaining cap is loose, the bottom pin may not be correctly aligned, which can happen in various situations, preventing a broken key from being removed. Check to see if the key is still placed in the same spot. Next, try to squeeze the key out by pushing against the plug’s face with your fingers. As you attempt to take the key out, you can insert the plug with the tip of your other hand.

Lubrication lock

If adjusting the alignment doesn’t solve the issue, a loose plug might not be the root of the issue. The most common cause of keys hanging on the tumbler pin is typically fresh, subpar keys. The next step is to attempt to facilitate extraction; for this, grab your go-to blue and red WD-40® Smart Straw container and lubricate as necessary. With the help of the clever nozzle, you can spray directly into keyholes and other small crevices to make it simpler for keys to slide out. Have a fresh rag on hand to mop up spillage. Now, try swinging the broken key up and down (instead of side to side) to unlock it. If this is successful, once it’s out, spray the lock again and turn your key to dispense the lubricant.

Use key extractor

You can make use of a key extractor, a specialist tool. These gadgets come in many different varieties, but they all function largely in the same way.

The following are the top two kinds:

a critical extraction hook. It has a hook at the end, as you might infer from the name. To remove it without harming the lock, you must carefully grip the broken portion of the key and insert it into the keyhole.

an extractor for spiral keys. It has a screwdriver-like appearance but is slimmer. You must turn it after inserting it until the key begins to turn.

Try glue stick

A glue stick can also be used to extract the key; all you have to do is melt it and apply it to the portion where the key protrudes from the lock. You might try slowly removing the key after making sure it is firmly connected. The damaged key must be located extremely near the keyway for this technique to be effective, though.

There are numerous techniques for removing a stuck key from a lock. The key will eventually break since most people find it very challenging to do this correctly. Therefore, keep in mind to operate as gently as possible. To check our selection of Lock Picking Kit, visit

Share this content:

Jared Nelson

Leave a Reply

Copyright © 2024 All rights reserved